Help!?

[BurlingtonBolts]

Do you know where I can easily find a list of the complete changes to the position requirements with the patch vs what we used to require ie this was the old one:


3 QB
3 RB
1 FB
2 TE
4 WR
2 C
3 G
3 T
1 K
1 P
3 DE
3 DT
3 OLB
2 ILB
4 CB
3 S

I know I have seen it several times but now I can't find it anywhere.

I have seen the list of changes for the initial patch but it just lists the basics 2 guards 2 tackles 1 center etc and not the full details ie for rb/fb you need 4 total etc...

Any help would be greatly appreciated.

Thanks!

[Cringer]

In your game, go to your roster and hit the F1 key. In the help file one of the things you will see is.........

Before adjusting your depth charts, you need to have a minimum number of players at each position. The minimums for each position are as follows:


Quarterback: 3
Running Back: 2
Fullback: 1
Tight End: 2
Wide Receiver (Flankers and Split Ends): 4
Center: 1
Offensive Guard: 2
Offensive Tackle: 2
Punter: 1
Kicker: 1
Defensive End: 2
Defensive Tackle: 2 (1 if you play a 3-4 defense)
Inside Linebacker: 1 (2 if you play a 3-4 defense)
Outside Linebacker: 2
Cornerback: 3
Safety: 2

The remaining 16 active players may be distributed at any position. However, you must also have a minimum number of players for each position group. Those minimums are as follows:

Backfield Members (Running Backs, Fullbacks): 4
Offensive Linemen (Centers, Guards, Tackles): 8
Defensive Linemen (Defensive Ends and Defensive Tackles): 6 (5 if you play a 3-4 defense)
Linebackers (Inside and Outside): 5 (6 if you play a 3-4 defense)
Secondary (Cornerbacks and Safeties): 7

This gives you an effective minimum of 41 active players and a maximum of 46. Any less than 41, with the positions distributed as above, and the computer AI will definitely make changes to your lineup at the start of a simulated game. Players who are listed as "out" in the injury report may not be made active for a game.

[BurlingtonBolts]

Thanks!

You are the man!

John